Repair Unattached Trip Lever In Wall Mount Sink

Slide the clevis about 2 inches along.

Repair unattached trip lever in wall mount sink.

Also the appearance of the sink is changed to something a bit more modern. Now you ll lift up and slide the sink off the bracket holding it to the wall then set aside tighten loose sink bracket. The plumbing should have an accurate position. The plunger piece provides the plug in the sink s drain assembly keeping the water that runs into the sink from draining out.

Turn off the water supply to the fixture at the two small water valves mounted on the wall beneath the sink. The floor sink should be placed in front of the plumbing. Exposed pipes are not aesthetically striking. This will also help hide the pipes and avoid any danger.

While it uses the same faucet handles as the previous version the spout is changed to a metal version and the trip lever for the drain rotates behind the spout. You should now see screws holding the bracket to the wall. Step 2 place a small bucket on the floor beneath the water valves to catch any water left in the lines then disconnect each of the lines with an adjustable wrench. Note the hexagonal escutcheons and metal cross handles.

You must detach the plunger from the sink s drain assembly in order to clear out large clogs or to replace the rubber pad on the underside of the plunger.