Removing Door Panel On 2011 Silverado

Then pull the door panel starting at a lower corner and lift the panel up.

Removing door panel on 2011 silverado.

Pry up the window switch panel. Also replaced the door handle cable. Remove the two 10mm bolts inside the door pull. Locate and remove the door panel retaining screw underneath the rear of the window control module cavity.

Just pull out the clips on the back. Disconnect the latch cables from the door handle with pliers. Remove the 10mm bolt inside the door handle. Lift the door panel up and off.

Free shipping on many items. Remove all door panel electrical connectors. 2011 door panel removal. Use a 7 mm socket wrench or a ratchet extension and 7 mm socket.

Gently lift panel up. Pull the lock up and pry out the panel on the lock. Then you want to do the same thing to the panel on the other side. Jan 24 2013 1 58pm i believe there s a little pin on the underside of the base on the inside release handle that when you push up it should pull right off.

How to on removing the door panel and replacing the inside door handle on dads 2013 gmc sierra 2500hd. Continue pulling on the bottom and sides of the panel to disengage all of the white plastic friction fasteners. Remove the door handle bezel by inserting a flat trim removal tool between the door panel and handle bezel to release the locking tabs. Then open the clip on the front of the door lock knob use something thin.

2011 chevrolet silverado 1500 134 10. Step 7 remove the retaining screw beneath the door pull handle with the socket wrench or ratchet. It just pulls right out. Lift the door panel up and out to release the door panel locking tabs.

Now reach in behind your door panel and just pull out to release the clips. Remove the two 10mm bolts underneath the handle. Life the lock up and off. 07 13 chevrolet silverado 1500 door panel rear right passenger black 1119 06 fits.

You need to remove the 2 bolts that hold the pull handle on there is 1 bolt behind the door handle that opens the door and there are 2 behind the handle that is directly behind the switches. We ll fast forward as don does this. Remove the panel under the handle. Disconnect the switch wiring harnesses.

Start off by prying up this panel behind the pole handle and then pry out this little panel beyond your door handle. Remove the door panel push pins and trim screws. Now you want to remove this 10mm bolt and these two 10mm bolts right here.