Also remove the small plastic door pocket bracket near the front of the door.
Removing 996 door panel.
Remove or fold weather strip at window sill into the panel.
Remove radio speaker grills.
The panel can be removed but it is tricky to deal with.
I just started up my car and.
Behind this plug is a hex screw.
You do not need to completely remove this panel.
Just lift it enough to gain access to the single torx bolt behind it.
Remove door storage compartment screw.
The 996 carrera panel is attached to the door using plastic clips green arrow.
1989 964 carrera 4 promotional video and showroom poster.
I need to remove the drivers door panel as there is a rattle in the door and a small amount of grease that the front window guide is depositing.
Pop a clip in mid of panel near sprk.
Remove 1 screw cab unclip panel at top rear at window sill.
To remove the door panel simply pull on the panel near where the plastic clips are located and they should pop right out of the holes in the door one shown by the yellow arrow.
Jacking up the 996 rear.
Saturday 22nd december 2012.
Any tips of removing the panel.
Start at the top top edge of inner door panel and follow the curvature.
Remove speaker remove screw behind spkr.
Page 41 www workshopmanuals co uk linings insulation 911 carrera 996 1 sticking sliding strip onto the rear of the inner door panel remove backing film from the sliding strip and stick the strip onto the rear of the inner door panel arrow.
Remove screw from.
Use the trim removal tool to remove the silver plug with airbag written on it.
Pull panel to front and up position.
Remove the door pull handle.
On 911 models open the door pocket lid and use a soft tool to pry up the panel the resides between the grab handle and the pocket lid.
Window problem reply reply author.
How to remove the door panel from a porsche 996.
There are three machine screws along the bottom edge of each pocket one sheet metal screw on each end and one sheet metal screw in the center under the pocket lid.