Removing 1997 Honda Accord Door Panel Plastic

Sometimes it s easier to get to the last connector by removing the whole switch assembly.

Removing 1997 honda accord door panel plastic.

When removing a honda accord door panel you must remove the panel using the proper tools and techniques. Pull the inner handle forward and out half way and disconnect the inner handle rod and power door lock connector. Remove the door panel with as little bending as possible to avoid creasing or breaking it. Remove the armrest screw.

Anyone can remove the door panel from an accord but if done wrong the door panel will be broken and will not fit back onto the door correctly. First there is a trianglular plastic piece in the corner nearest the windsheild. Remove the door panel by pulling it upward. You want to remove this piece in case you want to replace the window window motor or the power switch harness.

Now that that s loose push up on the whole thing off the door lock and get ready to disconnect some electrical connectors. You can now disconnect the electrical connectors on the window motor switch and the driver s master switch. The door panels of an accord can be removed to change the window. Just below it on the panel itself is a plastic snap plug usually same color as the door panel.

Xiter 4pcs abs engineering plastic car interior automobile door window control panel cover molding door lock switch trim accessories for honda accord 2018 2019 2020 red red 38 88 38. For the last one you can remove the courtesy light. Next there is a screw in the middle of the panel where the door lock switch window switch and door handle are located. Release the clips that hold the door panel.