Let the detergent sit for 45 minutes then pour boiling water on the area and vigorously scrub the stained section with the broom.
Remove water based paint from garage floor.
Step by step tutorial paint stripper method.
Saturate a rag with rubbing or denatured alcohol if the paint is still there.
The type of stripper you should use depends on the type of paint you are trying to remove such as water based or oil based paint.
If you re uncertain your best bet is to opt for an oil based paint stripper.
Another option is to use power washers where the pressure from the machine removes paint from concrete and generally works well with wet paint.
Wash the affected area.
There are other alternatives to chemical based passed strippers as well such as an orbital sander to remove paint from small areas of concrete or a floor buffer for larger areas.
Denatured alcohol a clean rag and a lot of patience can remove latex paint without damaging wood.
Use a contractor s broom to sweep away.
Pour dry dishwasher detergent or a concrete cleaning agent on the stain.
Clean the concrete surface and allow it to dry.
For stubborn stains use muriatic acid in combination with your pressure washer set to at least 1200 psi.
Step 1 prepare the concrete surface.
Absorbent paint stripper method.
It ll work on both oil based and water based paints and all it takes according to the spot removal guide is to point the heat gun at the paint and at the same time scratch the paint away with a putty knife.
Use another application of detergent followed by a rinse from your pressure washer or garden hose nozzle.
Thoroughly clean off from your garage floor any remaining chemical residue from paint strippers and or muriatic acid.
Once you ve covered the concrete with a generous layer of paint stripper let it sit for six to eight hours.
Then wipe over the floor with a damp rag for the final finish.
Soak up the moisture with paper towels.
If in doubt use a stripper designed for removing oil based paints 2 x research sourcestep 3 allow the.
Oil based paint spatters require mineral spirits but be careful not to soak the wood as this.
Lay the rag on the spot and leave it there for 20 minutes.
Pressurized water often works its.
Remove the rag scrap the spot with a putty knife then use the sponge and soapy water to scrub away any remaining paint.
Use a broom or shop vacuum to remove all dirt or debris.