Straighten a paper clip and insert it into the hole.
Remove storm door lock.
At this point the square tab on the spindle is aligned with the square.
Removal of the two types of locks is similar in many ways so here is a convenient step by step guide to show you how to remove the door lock from a storm door.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
This will loosen the tension on the deadbolt allowing it to retract and the door to open.
Once triggered the lever or lock trim can be removed from the door.
Regardless if the storm door lock is the type that uses a deadbolt or a keyed handle you will need to remove a pair of set screws that are located on the interior portion of the lock or the part of the lock that faces the interior of your home.
Check for any pinholes or depressions in the handle or around the trim.
Some locks designed for interior use may have these holes on the exterior side for homeowners who have lost the key.
Remove the screws and cover plates.
Slip a straightened safety pin into small holes or use a flat screwdriver to press against a slot or depression.
To unjam the deadbolt remove the installation screws on the latch rail from the outside.
Once the door is open operate the handle and turn the deadbolt.
Assemble the new exterior handle according to the instructions on the packaging and slide the spindle.
Steps for replacing the lock and hardware on a storm door step 1.
Discard the old handle.
Using an allen key loosen the set screw and remove the interior door handle.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
Remove the old handle and screen door latch unscrew both interior latch mounting screws pull the interior and exterior handles apart and remove the center spindle.
Step 1 remove the cylinders or handle assembly.
Tapping out or pulling out the pin is best done with the door closed because when the pin is released the closer will spring back an action that is minimized when the door is closed.
Use the pliers to pull the pin out if necessary.
Then use a phillips screwdriver or power screwdriver to take out the screws.
Loosen the set screw.