Remove Jeep Doors With Power Windows

Once you ve removed the nuts reach through the open window to grip the inside door handle.

Remove jeep doors with power windows.

This can be done with a t50 socket and ratchet. Heavy duty connectors are installed allowing doors to be removed. Lift the door straight up to disconnect it. It s also beneficial to lube the door stems and hinges when the doors are removed in order to make future removal easier.

Try putting the nuts on but just a couple turns and put a wrench on the nut and hit it the wrench with a rubber hammer and when you get the doors off put some bearing grease on the hinge and that will keep them lubed and easier to remove next time but remember to clean and regrease often. One power wire goes to the battery one goes to an ignition power source and the third gets grounded in the kick panel. Instructions 1 remove the door panel. The first step in the removal of jeep doors is to loosen and remove the t50 cap nuts on the door hinges.

Roll down the windows remove the door check arm unplug the wiring drop the two hinge bolts pull off the limit strap and lift it free. With the other hand grip the outside door handle. Use a 13 mm socket and turn counter clockwise to loosen the nuts. Lift the door straight up to disconnect it from the jeep.

The nuts are painted to match the body of the jeep so be very. Removing the doors 1. If you need more information on how to do that check out the door panel removal video. At the bottom of each of the two bolts that hold each door on the.

Be careful with the paint on the door hardware. Be careful not to damage the paint. 3 on a manual window use the crank to roll down the window halfway to give you access to the bolt that. The process is basically the same for the front and rear.

See more information on our jeep wrangler power window kit power door lock kits.