Remove Door Panel Ls1tech

Pry the panel off behind the door handle using a flat head screwdriver then remove the screw behind it.

Remove door panel ls1tech.

On others a gaping. Every key component of the ls1 camaro and firebird has been weighed. With the screws removed take the pry tool and move carefully around the panel popping it out of place. Keep your hands in position on the door s sides.

Adding power will generally cut into the budget but many items can be removed from the 4g f body to reduce the curb weight without spending a cent. Remove the screw inside the arm rest grab handle. Open your door up and locate the five screws that hold the door panel in place. Once you ve removed those five screws use a door panel removal tool or putty knife and work your way around the outside of the panel to release it from the plastic retention clips.

Removing the control panel and door latch 1 lift the door latch and remove the screw attaching it to the panel. Though the cracks tend to occur in the same location on each door panel roughly 8 inches inward from the rear they start small on some and can gradually lengthen over time. You can use a panel removal tool or flat head screwdriver to do this just be careful not to break the tabs that hold it in place. If you want to make your fourth generation chevrolet camaro or pontiac firebird with the ls1 v8 faster or quicker you can add more power or you can remove weight.

Step 1 remove door panel lift up on the window switch panel to remove it. There should be two screws on the bottom one behind the handle one in the middle and one towards the upper right. Hold the door handle latch open and look for a fastening screw at the base of the latch. Slide the tool between the door panel and door shell.

Lift both sides evenly until the door clears the hinges. This removes the clip from the retainer opening in the door panel and prevents the door panel backing from getting ripped. Lift and pull the door towards you to remove it. Step 1 remove the door panel begin by removing the two phillips screws located on the bottom of the door panel then remove the screw up near the side mirror.

Step 1 remove the door panel there are five phillips head screws that must be removed first all of which are located around the door handle. Use the door shell as leverage and push against the door shell. The open end of the blade slides over the clip stud.