Remove Door Panel 99 Ford Expedition

Pry the window switch bezel off the door panel using the trim tool.

Remove door panel 99 ford expedition.

Firmly pull out the bottom edge of the door panel to release the metal retaining clips. You need to take care various things before you remove door panels from a 1999 ford expedition. It is a slightly complex process but you need to see a variety of things before you start removing the door panels. Lift panel up off frame.

Remove the door handle latch bezel. Continue pulling out the friction fasteners all along the bottom edge and both sides of the door panel. Pry up the courtesy light. How to remove a 2001 ford expedition door panel.

For a 1999 ford econoline 150 assume the same or very similar remove triangular plastic cover over mirror assembly by prying straight out remove plastic door handle cover by prying up from the front side remove electronic door switches by prying up from back side remove round plastic cover at bottom rear of door panel. Open the door as wide as possible to give you room to work. Tilt away top edge. Unplug the light bulb.

You can purchase a trim tool at just about any automotive parts. Lift the door panel up and off. Pull out door lock stalk. Remove the triangle panel by prying up with a screwdriver and cloth.

The drivers side door is having problems with the window going up and down as well as the internal door handle not fuctioning properly. Unplug the window and door lock switch wiring harnesses from the underside of the switches by. How to take off the door panels on a ford expedition. Behind that panel there is a screw remove it.

Carefully lift the plastic door panel up and off the upper lip of the metal door frame. Removing door panels from any car is difficult. Drivers side door door handle door panel i have a 1999 ford expedition. Many car mechanics say that it is very difficult to remove door panels from this particular car.

Then remove the tiny triangular trim panel in the upper corner of the door. To remove the front door panel first use a flat screw driver and pop off the upper triangle cover from the door.