Remove And Install Outer Door Handle

Any mechanisms that have to be disconnected will be apparent at this point.

Remove and install outer door handle.

Slide the door handle toward the front of the car then the rear of the handle can be tilted out of the door. Pull the exterior door handle strap outward and to the rear to release it from the exterior door handle reinforcement. In order to gain access to the door handle mounting bolts and the linkage the interior door panel had to be removed. Once triggered the lever or lock trim can be removed from the door.

Remove the screws from the face plate behind the handle on the exterior side of the door using a screwdriver or drill driver. Remove the exterior door handle strap. Install a new door lock and door knob by inserting the latch through the hole for the new parts. Remove the plug from the rear of the door.

Apply a bit of pressure to the paper clip to trigger a release button inside the hardware. Remove all screws from the lever or doorknob on the inside. When this is done the front of the handle will be free to move and can also be slid out of the door in a similar fashion. If you have any further interest please visit http www 2carpros c.

Diy remove replace door s handle with hidden screws. In this video we use a gm vehicle to show you have to replace a broken outer door handle. There may be only one mounting screw at the base of the plate. Avoid damage to the screws by using a hand screwdriver.

First hope from corvette clinic removed the door pull and lock knob. Insert the lockset tailpieces through the latch bolt and screw the handles together by tightening the retaining screws. Straighten a paper clip and insert it into the hole.